Ethercat Settings; Parameter - Omron sysmac EtherCAT NJ101 Series Connection Manual

6. EtherCAT Settings

This section describes the parameter and device variables that are defined in this guide.
In the following sections, the Dry Vacuum Pump is referred to as the "slave unit" in some
descriptions.

6.1. Parameter

The following parameter is required to connect the Dry Vacuum Pump and the Controller via
EtherCAT.
Name
Dry Vacuum Pump
Additional Information
The node address can also be set using Sysmac Studio.
Refer to 2-2 Setting the Node Addresses of the EtherCAT Slaves of the NJ/NX-series CPU
Unit Built-in EtherCAT® Port User's Manual (Cat. No. W505) for information on how to set the
node address using Sysmac Studio.
Setting
Setting item
value
Node address 1
6．EtherCAT Settings
Remarks
By the ID Selector (hardware switch)
8