Omron E5CK User Manual page 86

The parameters in this mode can be used only when the "security" parameter (pro-
tect mode) is set to "0" and "1".
This mode contains the parameters for setting expanded functions. These parame-
ters include parameters for setting ST (self-tuning), setting the SP setting limiter,
selecting advanced PID and ON/OFF control, specifying the standby sequence reset
method, and automatic return of display mode.
To select this mode when in the levels 0 to 2, setup, option and calibration modes,
press the key for 1 second minimum. The display changes to the menu display.
If you select [ ] using the
mum, the controller enters the expansion mode.
To select parameters in this mode, press the
use the or keys.
The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
key then press the
Parameter Name
Set point upper limit
Set point lower limit
PID / ON/OFF
ST
ST stable range
α
AT calculated gain
Standby sequence reset method
Automatic return of display mode
AT hysteresis
LBA detection width
Expansion Mode
key for 1 second mini-
key. To change parameter settings,
Page
5-28
5-28
5-28
5-29
5-29
5-29
5-30
5-30
5-31
5-31
5-31
5--27