Adjusting Control Operation; Changing The Set Point - Omron E5CK User Manual

CHAPTER 3 BASIC OPERATION

3.7 Adjusting Control Operation

J Changing the set
point
Setting Example
J Manual operation
Balance-less,
Bump-less Opera-
tion
3--12
• You can change the set point in the "set point" parameter (level 0 mode).
• However, note that you cannot change the set point when the "security"
parameter (protect mode) is set to "6".
• To change the set point, press the
value. If you leave the setting for two seconds, the set point is updated
to the new setting.
In the following example, let's change the humidity set point from "60%"
to "50%".
(1) Select the PV/SP monitor display.
(2) Press the key to change the setting to "50.0: 50.0%".
• To set manual operation and manually set the manipulated variable,
press for 1 second minimum the
manual mode.
• The manipulated variable is displayed on the No.2 display. To change the
manipulated variable, press the
manipulated variable is updated to the new setting.
• Other modes cannot be selected while in the manual mode. To select
other modes, press for 1 second minimum the
is quit.
• The automatic return of display function does not work while in the
manual mode.
• When switching between manual and auto operation, the manipulated
variable is subject to balance-less, bump-less operation.
• If the power is interrupted during manual operation, manual operation
is resumed at the manipulated variable at power interruption when the
power is reset.
• You can switch the AUTO/MANUAL function up to 100,000 times.
To prevent sudden changes in the manipulated variable when switching between
manual and auto operation, operation is resumed using the value that was active
immediately before operation was switched, and the value is brought gradually
closer to the value immediately after operation was switched.
or keys to select the desired
key. The controller enters the
A/M
or keys. After two seconds, the
key. The manual mode
A/M