Calibration - Omron E5CK User Manual

4.5 Calibration

Thermocouple 1
Transfer output
Data save
To calibrate the E5CK controller, select [
select the calibration mode. [
However, note that [
when, for example, the user is calibrating the E5CK controller for the
first time. If this happens, [
rity" parameter (protect mode) to "0".
The parameters in the calibration mode are configured as follows.
Platinum resistance
Thermocouple
thermometer
Thermocouple 2
Only when transfer
output function is
supported
To select the desired parameter, press the
played in the following order:
Calibration of inputs
Saving of calibration data
If the E5CK controller does not support the transfer output function,
calibration of transfer output is automatically deleted from the calibra-
tion procedure as follows:
Calibration of inputs
Only inputs that have been set in the "input type" parameter (setup
mode) can be calibrated. To temporarily save data for each of the calibra-
tion parameters, press the
Transfer output can be calibrated only when the communications unit
(E53-CKF) is set in the controller. To adjust data items, press the
or keys.
The data save menu is displayed only when all calibration items have
temporarily been saved.
After calibrating input, you must always check indication accuracy. For
details, see page 4-20.
] is displayed.
] may not be displayed on the menu display
] is displayed by changing the "secu-
Current input
Thermocouple 1 : K1/J1/L1/E/N/W/PLII
Thermocouple 2 : K2/J2/L2/R/S/B/T/U
Platinum resistance
: JPt100/Pt100
thermometer
Calibration of transfer output
Saving of calibration data
key for 1 second.

4.5 Calibration

] in the menu display to
Voltage input
0 to 5V 1 to 5V 0 to 10V
key. Parameters are dis-
4--11