Output; Parameters And Menus; Selecting Modes - Omron E5CK User Manual

F Option mode
F Calibration mode
J Selecting modes
F Menu display
F Level 0 to 2
modes
This is the mode for setting option functions. You can select this mode only
when the option unit is set in the controller. In this mode, you can set the
communications conditions, transfer output and event input parameters
to match the type of option unit set in the controller.
This mode is provided so that the user can calibrate inputs and transfer

output.

When calibrating input, the selected input type is calibrated. Whereas,
transfer output can be calibrated only when the communications unit
(E53---CKF) is set in the controller.
The following diagram shows the order in which modes are selected.
1 second min.
Level 0 mode
1 second min.
Level 1 mode
1 second min.
Level 2 mode
1 second min.
Setup mode
1 second min. Expansion
mode
1 second min.
Option mode
1 second min.
Calibration
mode
• To select the menu display in any of the above modes (excluding the pro-
tect mode and manual mode), press the
If you select the desired mode using the
key, the top parameter in the specified mode is displayed.
• When you have selected the menu display, the previous mode is selected.
For example, if you selected the menu display while in the level 0 mode,
the No.2 display changes to [
• Protected modes cannot be selected. Also, the menu display does not
appear when modes are protected up to the level 1 mode.
• If you select [ ] [
level 1 and level 2 modes, respectively, are selected.
• These modes are selected with control still continuing.

1.3 Parameters and Menus

Power ON
A/M
1 second min.
] as shown on the left.
] or [ ] in the menu display, the level 0,
Manual mode
A/M
1 second min.
+ +
A/M A/M
1 second min. 1 second min.
Protect mode
+
A/M
1 second min.
key for 1 second minimum.
or keys and press the
1--7