Setting Up The Output Unit; Setting Up The Option Unit - Omron E5CK User Manual

J Setting up the output unit
F Output unit list
F Setup
J Setting up the option unit
F Option unit list
F Setup
The following table shows the output units that can be set in the E5CK
controller.
Model
E53-R4R4 Relay/Relay
E53-Q4R4 Voltage (NPN)/Relay
E53-Q4HR4 Voltage (PNP)/Relay
E53-C4R4 4 to 20 mA/Relay
E53-C4DR4 0 to 20 mA/Relay
E53-V44R4 0 to 10 V/Relay
E53-Q4Q4 Voltage (NPN)/Voltage (NPN)
E53-Q4HQ4H Voltage (PNP)/Voltage (PNP)
The following table shows the option units that can be connected to the
E5CK controller.
Unit
Communications unit
Communications unit
Input unit
Communications unit
Specifications
(control output 1/control output 2)
(1) Two rectangular holes for slotting are pro-
vided on the power board (on right side of
controller). Fit the two protrusions on the
output unit into these two holes.
(2) With the output unit fitted into the power
board, fit the output unit into the connector
on the control board (on left side of control-
ler).
Model
E53-CK01 Communications (RS-232C)
E53-CK03 Communications (RS-485)
E53-CKB Event input: 1 input
E53-CKF Transfer output: 4 to 20 mA
(1) Place the controller with its bottom facing
up, and fit the board horizontally into the
connector on the power board (on right side
of controller).
(2) With the power board connected, fit the
board vertically into the connector on the
control board (on left side of controller).
2.1 Setting up
Specifications
2--3