CHAPTER 5 PARAMETERS
Setup Mode
_C/_F selection
This parameter can be used when thermocouple or platinum resistance thermometer
is selected as the input type.
Set the temperature input unit to either of "_C" or "_F".
Function
Comment
F Related article
3.2 Setting Input Specifications (page 3-3)
F Related parameter
See
"Input type" (setup mode)
Control output 1 assignment
Control output 2 assignment
Assigns the output functions to either of control output 1 or 2.
The following six output functions can be assigned as outputs:
Function
Errors 1 and 2 cannot be assigned as outputs.
When the output function assigned to control output 1 is ON, the OUT1 LED lights.
However, note that the OUT1 LED does not light when control output (heat) or control
output (cool) are assigned to linear outputs such as current and voltage.
When the output function assigned to control output 2 is ON, the OUT2 LED lights.
Function
Defaults:
Comment
"Control output 1" = [
F Related article
3.3 Setting Output Specifications (page 3-5)
F Related parameters
See
Alarm-related parameters
Heating and cooling related parameter
"LBA detection time" (level 2 mode)
5--24
Setting Range
: _C /
: _F
Control output (heat), Control output (cool), Alarms 1 to 3, and LBA.
Symbol
Control output (heat)
Conditions of Use
The input type must be set to temperature
input (thermocouple or platinum resis-
tance thermometer).
Default
Alarm 1 Alarm 2 Alarm 3
Control output (cool)
], "Control output 2" = [
LBA
]