Set Point During Sp Ramp - Omron E5CK User Manual

Set point during SP ramp

Sets the set point.
Function
SP setting lower limit to SP setting upper limit
Monitor
F Related article
3.7 Adjusting Control Operation (page 3---12)
F Related parameters
See
"PV/SP" (level 0 mode)
"SP ramp time unit" "SP ramp set value" (level 2 mode)
"Set point upper limit" "Set point lower limit (expansion mode)
MV monitor (heat)
MV monitor (cool)
This parameter cannot be set.
Monitors the manipulated variable on the heating or cooling side.
The manipulated variable in a standard control system is checked in the "MV moni-
Function
tor (heat)" parameter.
The "MV monitor (cool)" parameter can be used only during heating and cooling con-
trol.
MV monitor (heat)
Standard
Monitor
Heating and cooling
MV monitor (cool)
Heating and cooling
Moniter Range
Control
Monitor Range
-5.0 to 105.0
0.0 to 105.0
Control
Monitor Range
0.0 to 105.0
Level 0 Mode
Conditions of Use
The SP ramp function must be enabled.
Unit Default
EU 0
Unit
%
%
Unit
%
5--7