CHAPTER 6 USING THE COMMUNICATIONS FUNCTION
6.6 Program Example
J How to use programs
The program described below is for obtaining corresponding response frame data when
some of the command frame data is input.
The input format is as follows. The FCS and terminator are automatically generated,
and need not be input.
@
The output format is as follows. The content of the response frame is displayed as it is.
@
F Procedure
(1) Read the program.
(2) Enter "RUN".
(3) When "send data:" is displayed, enter the command data (from @ to the command
(4) The content of the response frame is displayed following "receive data:".
F Conditions when running a program
Set the communications condition as follows:
Make sure that the communications cable is properly connected.
6--12
2B
1B
2B
Unit
Command
code
No.
Command type
Input data
2B
1B
2B
Unit
Command
End
code
No.
code
Command type
string).
Baud rate
:
9600 bps
Bit length
:
7 bits
Parity
:
Even
Stop bit
:
2
4B
2B
FCS
Data
Automatically
generated
2B
4B
Data
2B
*
CR
2B
2B
FCS
*
CR