Using The Simple Program Function; Simple Program Function - Omron E5CN User Manual

Using the Simple Program Function

4-15 Using the Simple Program Function

4-15-1 Simple Program Function

Parameters Related to the Simple Program Function
Parameter name Symbol
ptrn
Program pattern
prst
Program start
soak
Soak time
t-u
Soak time unit
wt-b
Wait band
sktr
Soak time remain
monitor
Note
104
• The simple program function can be used for the following type of control.
SP
Set point
PV
RSET STRT
• The program will start when the "program start" parameter is changed
from RSET to STRT. END will be displayed on the No. 2 display and the
output assigned as the program end output will turn ON after the time set
in the "soak time" parameter has expired in the wait band. The "program
pattern" parameter can be used to select moving to STOP mode or con-
tinuing operation in RUN mode after the program ends.
Set (monitor) values
OFF, STOP, CONT
RSET, STRT
1 to 9999
m (minutes)/h (hours)
OFF or 0.1 to 999.9 (See note 2.)
0 to 9999
(1) Set for Controllers with Thermocouple/Resistance Thermometer Multi-in-
puts. Set "none" as the unit for Controllers with Analog Inputs.
(2) The setting unit of the "wait band" parameter is %FS for Controllers with
Analog Inputs and the setting range is OFF or 0.01 to 99.99.
Soak time
Select either
STOP or RUN.
Unit
--- Initial setting level
--- Operation level
min or h Adjustment level
--- Advanced function set-
ting level
C or F (See notes 1 Adjustment level
and 2.)
min or h Operation level
Section 4-15
Wait band
Wait band
END display
END output
Display level