Omron E5CN User Manual page 240

Note (1)
Transfer output
Set point
Set point during SP
ramp
PV
MV monitor (heating) Standard: 5.0 to 105.0
MV monitor (cooling) 0.0 to 105.0
(1.1) Initialized when the transfer output type is changed.
Initialized if the input type, temperature unit, scaling upper/lower limit, or SP upper/
lower limit is changed when the transfer output type is SP, ramp SP, or PV.
(When initialized by the initializing settings, it is initialized to 100.0/0.0.)
(2) The setting range depends on whether control output 1 is a linear output or pulse output.
(3) When setting CWF, either CompoWay/F or SYSWAY can be used as the communications protocol.
(CompoWay/F and SYSWAY are automatically identified by the command frames.)
(4) P.END (program end output) can be set when the program pattern is not set to 0 (OFF).
(5) PRST (program start) can be set when the program pattern is not set to 0 (OFF).
(6) Set "none" as the unit for Controllers with Analog Inputs.
218
Setting (monitor) range
type
SP lower limit to SP upper limit
SP lower limit to SP upper limit
Temperature: Sensor setting
range lower limit to sensor set-
ting range upper limit
Analog: Scaling lower limit to
scaling upper limit
Heating/cooling: 0.0 to 105.0
Default (transfer output
upper/lower limits) (See
note 1.1.)
SP upper limit/lower limit
SP upper limit/lower limit
Sensor setting range upper/
lower limit
Scaling upper/lower limit
100.0/0.0
100.0/0.0
Appendix A
Unit
EU
EU
EU
EU
%
%