Omron E5CN User Manual page 127

Using the Simple Program Function
Program Pattern
Either of two program patterns can be selected. The simple program opera-
tion will not be performed if the "program pattern" parameter is set to OFF.
■ Pattern 1 (STOP)
Control will stop and the STOP mode will be entered when the program has
ended.
Set point
PV
RSET STRT
■ Pattern 2 (CONT)
Control will continue in RUN mode when the program has ended.
Set point
PV
RSET STRT
The pattern display and setting range will change as shown in the following
table when a program mode is set in the "program pattern" parameter.
Item
Displayed parame-
ters
Control output 1/2
assignment
Alarm 1/2/3 assign-
ment
Setting range
Event input assign-
ment 1/2 setting
range
Soak time
Automatically switches
from RUN to STOP mode.
Soak time
RUN mode continues.
Program mode not selected
There are no parameters that
are not displayed if a program
mode is set.
Not assigned.
Control output (heating)
Control output (cooling)
Alarm 1
Alarm 2
Alarm 3
Not assigned.
RUN/STOP
AUTO/MANUAL
Section 4-15
Wait band
Wait band
END display
END output
Wait band
Wait band
END display
END output
Program mode selected
• Program start
• Soak time
• Soak time unit
• Wait band
• Soak time remain
Not assigned.
Control output (heating)
Control output (cooling)
Alarm 1
Alarm 2
Alarm 3
Program end output
Not assigned.
RUN/STOP
AUTO/MANUAL
Program start (RESET/
START)
105