Omron E5CN User Manual page 203

Advanced Function Setting Level
t-u
Soak Time Unit
Function
Setting
See
See
alsp
Alarm SP Selection
Function
Setting
See
See
cmov
Move to Calibration Level
Function
See
See
• Set the soak time unit for the simple program function.
Setting range
m: Minutes, h: Hours
■ Related Parameters
Program start, Soak time remain (operation level): Page 123
Soak time, Wait band (adjustment level): Page 141
Program pattern (initial setting level): Page 151
This parameter sets whether the set point that triggers a deviation alarm dur-
ing SP ramp operation is to be the ramp SP or target SP.
• Set whether the set point that triggers a deviation alarm is the ramp SP or
target SP.
Setting range
sp-m: Ramp SP, sp: SP
■ Related Parameters
SP ramp set value (adjustment level): Page 143
ST (initial setting level): Page 150
This parameter sets the password to move to the calibration level.
• Set the password to move to the calibration level. The password is 1201.
• Move to the calibration level either by pressing the M key or O key or by
waiting for two seconds to elapse.
■ Related Parameter
Initial setting/communications protect (protect level): Page 116
Section 5-7
The "program pattern" parameter
must not be set to OFF.
Default
m
Alarm 1, 2, and 3 functions must be
assigned.
The "SP ramp set value" and "ST"
parameters must not be set to OFF.
The alarm type must set to a devia-
tion alarm.
Default
sp-m
Initial setting/communications protect
must be 0.
181