Omron E5CN User Manual page 182

Advanced Function Setting Level
Note
See
See
ev-1
Event Input Assignment 1
ev-2
Event Input Assignment 2
Function
Setting
Note
See
See
mspu
Multi-SP Uses
Function
Setting
160
Event input 1
OFF
ON
Event inputs can be used on E5@N-@@@B@ Controllers. Turn the event
inputs ON or OFF while the power is turned ON. Event input ON/OFF
changes are detected for inputs of 50 ms or longer.
■ Related Parameters
SP 0 to SP 3 (adjustment level): Page 136
Event input assignment 1, Event input assignment 2: Page 160, Multi-SP
uses: Page 160 (advanced function setting level)
• The following functions are assigned for event input 1 and event input 2.
RUN/STOP
Auto/manual switch
Program start
• Defaults:Event input assignment 1: none
Event input assignment 2: stop
Settings
none
None
stop
RUN/STOP
manu
Auto/manual switch
prst
Program start (See note.)
This parameter can be set when the program pattern is not set to OFF.
■ Related Parameters
SP 0 to SP 3 (adjustment level): Page 136,
Number of multi-SP uses (advanced function setting level): Page 159
This parameter enables switching between set points 0 to 3 by operating the
keys on the front panel.
Prerequisites
• A model without event inputs
• The "number of multi-SP uses" parameter set to 0 on a model with event
inputs
on: Set points 0 to 3 can be selected.
off: Set points 0 to 3 cannot be selected.
• Default : OFF
Event input 2
ON Set point 2
ON Set point 3
Event inputs must be supported.
The "number of multi-SP uses"
parameter must be set to 0 or 1.
Function
The model must not support event
inputs, or the number of multi-SP
uses must be 0.
Section 5-7
Selected set point