Engine Block
Specifications
Torque Specifications
DESCRIPTION
Connecting Rod Cap Bolts
Main Bearing Cap Bolts
Lower Cylinder Block Bolts
Clearance Specifications
DESCRIPTION
Surface Distortion Limit
Inner Diameter Standard
Out-Of-Round
Taper
Disassembly
1. Remove the oil pan and then remove oil baffle.
2. Remove the oil strainer.
3. For each connecting rod/piston assembly to be removed, rotate the crankshaft to the bottom dead center position
for each cylinder.
NOTE :
Before removing the connecting rod/piston assembly, check the connecting rod side clearance.
50
02–
ENGINE UNIT REPAIR
TORQUE (N·m)
1st Step: Tighten the bolt to 25 N·m
2nd Step: Tighten the bolt an additional 90°
1st Step: Tighten the bolt to 45 N·m
2nd Step: Tighten the bolt an additional 180°
23
SPECIFICATION (mm)
0.15
81
< 0.008
< 0.01
Chery Automobile Co., Ltd.
BESM020060