Timing Belt Automatic Tensioner Removal & Installation (2.4L) - Chery Tiggo 2009 Service Manual

Timing Belt Automatic Tensioner
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• MD-998767 - Automatic Tensioner Socket
1. Remove the engine timing belt (See Engine Timing Belt Removal & Installation in Section 02 Engine).
2. Remove the timing belt automatic tensioner bolts
(1).
(Tighten: Timing belt automatic tensioner bolts to
24 N·m)
3. Installation is in the reverse order of removal.
Installation Notes:
• Perform the following to prepare the automatic tensioner for installation:
− Slowly close the vise jaws until the rod hole
(1) and housing hole (2) are aligned.
− Insert a steel wire (1.4 mm diameter) into the
aligned hole.
− Remove the automatic tensioner from the
vise.
• The automatic tensioner is now ready to be installed on the engine.
196
02–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM020233
LTSM020070