Engine Block
Specifications
Torque Specifications
DESCRIPTION
Connecting Rod Cap Bolts
Main Bearing Cap Bolts
Lower Cylinder Block Bolts
Cylinder Bore Specifications
DESCRIPTION
Surface Distortion Limit
Inner Diameter Standard
Out-Of-Round
Taper
Disassembly
1. Remove the oil pan and then remove the oil baffle.
2. Remove the oil strainer.
3. For each connecting rod / piston assembly to be removed, rotate the crankshaft to the bottom dead center posi-
tion for each cylinder.
NOTE :
Before removing the connecting rod / piston assembly, check the connecting rod side clearance.
Chery Automobile Co., Ltd.
ENGINE UNIT REPAIR
TORQUE (N·m)
1st Step: Tighten the bolt to 25 ± 3 N·m
2nd Step: Tighten the bolt an additional 90 ± 5°
1st Step: Tighten the bolt to 45 ± 5 N·m
2nd Step: Tighten the bolt an additional 180 ±10°
20 ± 3
SPECIFICATION (mm)
0.15
73.005 ± 0.005
Less than 0.008
Less than 0.01
02
BESM020060
53
02–