Chery Tiggo 2009 Service Manual page 201

• MD-998442 - Hydraulic Post Wiring
• MD-998713 - Camshaft Oil Seal Installer
• MD-998441 - Hydraulic Post Keeper
• MD-998440 - Leak Tester
1. Remove the accessory drive belt (See Accessory Drive Belt Removal & Installation in Section 02 Engine).
2. Remove the engine timing belt (See Engine Timing Belt Removal & Installation in Section 02 Engine).
3. Remove the cylinder head cover (See Cylinder Head Cover Removal & Installation in Section 02 Engine).
4. Using special tools MD-998719 (1) and MB-990767
(2) remove the camshaft timing belt pulley bolt.
(Tighten: Camshaft timing belt pulley bolt to
120 N·m)
5. Remove the camshaft timing belt pulley.
6. Remove the intake and exhaust rocker shaft
assembly retaining bolts (2).
(Tighten: Rocker shaft assembly bolts to 32 N·m)
7. Remove the rocker arm and rocker shaft assem-
blies.
CAUTION: Before disassembling the rocker arm
and rocker arm shaft assembly, install special
tool MD-998443 (1) as shown in the illustration
to prevent the hydraulic adjusters from drop-
ping into the cylinder head.
8. Remove the camshaft position sensor electrical connector.
9. Remove the camshaft position sensor. (See Camshaft Position Sensor Removal & Installation in Section 03 Elec-
tronic Engine Controls).
10. Remove the camshaft thrust plate retaining bolt.
(Tighten: Camshaft thrust plate bolt to 19 ± 3 N·m)
11. Remove the O-ring.
12. Remove the camshaft.
13. Installation is in the reverse order of removal.
172
02–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM020056
LTSM020082