Recalling Previous Job Settings
Follow the procedure below to copy with a previous job's settings.
• Only the last-completed output job settings can be recalled as the
previous job settings. Non-complete job or reserve job settings cannot be
recalled, even if the setting operations have been made last.
• The previous job settings can be recalled, even after the machine power is
turned off then on.
1.
Press [JOB MEMORY] on the control panel.
The Job No. Selection Screen will be displayed.
2.
Touch PRE-JOB RECALL.
The JOB CHECK key will be displayed between STORE and PRE-JOB
RECALL on the screen
3.
Touch JOB CHECK to display the Job Check Screen.
Check the settings of the previous output job.
4.
Touch OK to return to the Basic Screen.
The settings of the previous output job is recalled on the screen.
5.
Change the settings recalled on the screen, if desired.
6.
When all settings are acceptable, position original(s) in the
document feeder or on the platen glass, then press [START].
Recalling Previous Job Settings
4-15