Table of Contents
Advertisement
Making Single-Sided Copies from Double-Sided Originals
2.
Check and specify the original set direction and binding mode.
The Original direction icon is located at the upper left corner of the Basic
Screen.
To change the original set direction, touch SPECIAL ORIGINAL on the Basic
Screen to display the Special Original popup menu, then touch the desired
original direction key to highlight it.
If double-sided originals are upside down on the reverse side and you want to
make single-sided copies of the same direction, touch TOP BIND.
Touch OK to return to the Basic Screen.
3.
Select additional copy conditions, as desired.
4.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
5.
Position originals FACE UP in the document feeder.
• See p. 3-4 for details on positioning originals.
• Use RADF store mode (p. 3-38) when the original count exceeds 100.
6.
Press [START].
The machine starts to scan originals, then prints simplex copies when ready for
output.
STOP
Press [
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
] to suspend the scanning or printing job. See p. 3-15 for details.
3-37
Hide quick links:
Advertisement
Table of Contents
