Erasing Outside of the Original (Non-Image Area Erase)
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select magnification and paper size, as desired.
• APS and AMS are automatically released.
• Copy mode is automatically set to 1)1. If 1)2 is selected, Platen store
mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
DO NOT CLOSE THE DOCUMENT FEEDER.
Original size should be larger than 10mm x 10mm.
7.
Press [START].
Having Any Problem?
This function may perform incorrectly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representative
about an appropriate place for installation.
10-35