Table of Contents
Advertisement
Copying Image in the Centre of Copy Paper (AUTO Layout)
• Non-Image Area Erase will be selected automatically. When using RADF to
scan the original, touch to deselect this function.
• If Dual Page is used with this function, the original smaller than the
selected paper size will be printed in the centre of the copy paper without
image division performed.
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic
Screen.
• APS and AMS are automatically released, and 1.000 (100%) is selected as
a magnification ratio.
• Copy mode is automatically set to 1)1. If 1)2 is selected, Platen store
mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-10 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
For details on positioning originals, see p. 3-4.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
Having Any Problem?
The AUTO layout function may not operate properly if the lighting in the work
place is directly over the platen glass. In this case, consult your service
representative about an appropriate place for installation.
10-48
Hide quick links:
Advertisement
Table of Contents
