When "Memory Full" Message Is Displayed (Memory Overflow); Displays; Check Output After Copying - Konica Minolta 7020 Instruction Manual

When "Memory Full" Message Is Displayed (Memory Overflow)

In certain modes, this printer/copier uses memory to make operations convenient
and smooth flowing. Occasional memory overflow may occur if the installed memory
is inadequate for the copy conditions selected.
Memory overflow messages are displayed as follows:
If continuous working

check output after copying

-Memory full - Start => START key
To handle the Memory overflow condition while in a job, take the appropriate action
indicated below. These actions enable you to continue the job or suspend the job.
I When
If continuous working
check output after copying
The above message displays when copying in Group
mode without Store mode selected.
1
Wait until the current operation is
completed.
When the machine stops copying after
producing one copied set irrespective of the
set print quantity, all the data in memory will
be erased.
2
Check the original pages, then position
originals again.
3
Press
START
5-10
Cancel => ST/CL key
HINTS
Should memory overflow occur frequently, it is recommended
that you contact your Konica service centre to extend the
memory capacity in your machine.
to complete the job.

Displays

Positioning the same number
of originals may cause the
memory overflow again.
Arrange the original pages to
lighten a burden to memory.