System Menu - Genicom microLaser 210 User Giude

System Menu

The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text "System Menu" is shown on the second line of the dis-
play.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.
5. Press the SELECT button to enter a submenu.
6. Use the procedures in the following table to access and change the system settings:
Submenus
Factory Defaults
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults.
Display Language
This submenu allows you to change
the language of the display
messages.
Power Saver
This submenu allows you to set the
number of minutes the printer is
idle before it reverts to Power
Saver Mode.
Wait Timeout
This submenu allows you to
increase or decrease the length of
time (in seconds) that the printer
will remain in the waiting state—a
job is being processed, no
end-of-file has been detected, and
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.
Job Timeout
This submenu allows you to
increase or decrease the time limit
(in seconds) for PostScript jobs. A
0 setting indicates no timeout. This
setting applies only to PostScript
jobs.
Mar 00
Default Setting Available Settings
U.S. U.S.
Non-U.S.
English English
French
German
Italian
Spanish
15 0 - 999
20 0 - 99999
0 0 - 99999
Genicom
microLaser 210 User Guide 3-13
System Menu
Procedure for Changing Setting
1. Press NEXT or PREVIOUS to toggles
between U.S. and NON-U.S.
2. Press SELECT to choose and set
the factory defaults.
1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set
the language.
1. Press NEXT or PREVIOUS to
increase or decrease the number of
minutes.
2. Press SELECT to save this setting.
1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
Publication No. GEG-99054