Correcting Miscellaneous Offset Catch Tray Problems - Genicom microLaser 210 User Giude

NOTE: If the main paper tray is in the extended position, remove the tray before opening the rear
cover.
5. Close the rear cover.

Correcting Miscellaneous Offset Catch Tray Problems

Some offset catch tray problems may not cause an error message and may not interfere with the
operation of the printer. If you are experiencing one of the problems listed below and there is no
error message shown on the control panel display, refer to the procedures in the following sections
to check the possible causes of the specific problem.
Inoperative offset catch tray
I
Erratic operation
I
Unusual noise
I
Inoperative Offset Catch Tray
The following characteristics define this feeder problem:
The offset catch tray appears to be inoperative.
I
When attempting to print to the offset catch tray, the offset catch tray does not respond and
I
does not transport paper.
The control panel does not display an error code.
I
Mar 00
Solving Offset Catch Tray Problems
Genicom
microLaser 210 User Guide 9-13
Publication No. GEG-99054