Error Messages - Genicom microLaser 210 User Giude

5-28 microLaser 210 User Guide
Warning Messages and Error Messages

Error Messages

The table below lists error messages, the possible causes of each error, and the actions required to
recover from each error.
Error Message
Line 1
E2 JAM MISFEED
E3 JAM FUSER
E4 EXIT JAM
E6 JAM OFF. TRAY
E7 JAM DUPLEX
E5 COVER OPEN
E5 COVER OPEN
J3 TONER CART.
TRAY 1 MISSING
TRAY 2 MISSING
TRAY 3 MISSING
LOAD PAPER TRAY1
LOAD PAPER TRAY2
LOAD PAPER TRAY3
LOAD PAPER FRONT
PAPER SIZE ERROR
OUTPUT TRAY FULL
OFFSET TRAY FULL
PAPER PATH ERROR
Publication No. GEG-99054
Error Message Possible Cause
Line 2
Remove Paper There is a paper jam
inside the printer.
Close Top Cover The top cover is open.
Close Rear The rear cover is open.
Cover
Install/Reset The toner cartridge is
not installed, or an
incorrect cartridge is
installed.
Insert Tray Tray 1 is not in the
printer.
Insert Tray Tray 2 is not in the
optional feeder.
Insert Tray Tray 3 is not in the
optional feeder.
Paper Size/ Tray 1 is empty.
Paper Type
Paper Size/ Tray 2 is empty.
Paper Type
Paper Size/ Tray 3 is empty.
Paper Type
Paper Size/ The front tray is empty.
Paper Type
Paper Size/ The paper size is not
Press Start supported by the
printer.
Remove Paper The output tray is full.
Remove Paper The offset output tray is
full.
Close Face Up The face up tray is
open.
Genicom
Action
Remove the jammed paper from
the indicated location.
See the "Paper Jams" on page
5-4 for information about
removing paper jams.
Close the top or rear cover.
Close the offset tray cover.
Install the correct toner cartridge
according to the specifications.
See "Replacing the Toner
Cartridge" on page 4-3.
Insert the tray.
Insert the tray.
Insert the tray.
Load paper into the tray.
Load paper into the tray.
Load paper into the tray.
Load paper into the tray.
Check paper size specifications
and load paper that meets
specifications.
Remove paper from the tray.
Remove paper from the tray.
Close the face up tray.
Mar 00