System Menu - Genicom Intelliprint ML450 User Manual

System Menu

The system menu provides access to system settings. Use the following procedure to enter the system menu:
Press the MENU button on the control panel.
1.
Press the NEXT button until the text " System Menu " is shown on the second line of the display.
2.
Press the SELECT button to enter the system menu.
3.
Press the NEXT button to move through the submenus: Factory Defaults, Display Language,
4.
Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, and Toner Out.
Press the SELECT button to enter a submenu.
5.
Use the procedures in the following table to access and change the system settings:
6.
Submenus
Factory Defaults
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults.
Display Language
This submenu allows you to change
the language of the display
messages.
Alarm Control
This submenu allows you to set the
alarm control.
Power Saver
This submenu allows you to set the
number of minutes the printer is
idle before it reverts to Power
Saver Mode.
Wait Timeout
This submenu allows you to
increase or decrease the length of
time (in seconds) that the printer
will remain in the waiting state—a
job is being processed, no
end-of-file has been detected, and
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.
Aug 01
GENICOM LN45 and Intelliprint mL450 User Guide 4-17
Default Setting Available Settings
U.S. U.S.
Non-U.S.
English English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish)
Single Single
Continuous
Off
15 0 - 999
20 0 - 99999
Genicom
Pushbuttons
Procedure for Changing Setting
1. Press NEXT or PREVIOUS to toggle
between U.S. and NON-U.S.
2. Press SELECT to choose and set the
factory defaults.
1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set the
language.
1. Press NEXT or PREVIOUS to move
among the alarm settings.
2. Press SELECT to choose and set the
alarm setting.
1. Press NEXT or PREVIOUS to
increase or decrease the number of
minutes.
2. Press SELECT to save this setting.
1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
Publication No. GEG-99126