Major Components Of The Offset Catch Tray; Installing The Offset Catch Tray - Genicom microLaser 210 User Giude

Major Components of the Offset Catch Tray

The following illustration shows the major components of the offset catch tray:.

Installing the Offset Catch Tray

Before installing the offset catch tray, remove it from its packaging and verify that you have received
an offset catch tray and that it is in good condition. If any part of the offset catch tray is missing or
damaged, contact your dealer.
Throughout this procedure, the different sides of the printer are referred to as front, rear, left, and
right. The front of the printer is the side that holds the control panel. The left and right sides are
those to the left and right, respectively, of a person facing the front of the printer.
Use the following procedure to install the offset catch tray:
1. Remove any cardboard inserts or packing tape from the interior and exterior of the offset
catch tray.
2. Turn the printer off by pressing [ O ] on the power switch on the front left of the printer, and
disconnect the power cord from the AC outlet.
Mar 00
Output Tray
Paper Stop
Fitting
Figure 9-2: Offset Catch Tray Major Components.
Genicom
microLaser 210 User Guide 9-3

Installing the Offset Catch Tray

Paper Guide
Publication No. GEG-99054