Table of Contents
Advertisement
10.
Push the tray in until it matches the size of paper that will be printed.
11.
Insert the plug of the power cord into the AC outlet and turn the printer on by pressing
[ I ] on the power switch on the front left of the printer.
12.
Check the display to make sure the printer is ready for printing.
NOTE:
If an error message is shown when you turn the printer on, refer to Chapter 5:
Troubleshooting.
Removing the Offset Catch Tray
Use the following procedure to remove the offset catch tray:
1.
Pull the output tray all the way out and lower the paper stop.
Mar 00
Removing the Offset Catch Tray
Genicom
microLaser 210 User Guide 9-7
Publication No. GEG-99054
Advertisement
Table of Contents
