Table of Contents
Advertisement
To Scan Originals into Memory (Store Mode) (continued)
Using RADF:
Position originals with page one FACE UP. Up to 100 originals can be
loaded.
If the number of originals exceeds 100, divide them into blocks not
exceeding 100 sheets and load them beginning with the block with the first
page.
Be sure to check the original direction according to the Original direction
icon displayed at the upper left corner of the Basic Screen.
The copy result may not be satisfactory if the originals are set in wrong
direction. Be sure that the originals are set in the same direction as indicated
by the Original direction icon, especially when making double-sided copies or
using Staple, STITCH&FOLD, Fold, or Booklet mode. See p. 9-2 to p. 9-3 for
details.
See p. 3-4 to p. 3-9 for details on positioning originals.
5.
Press [START] to scan.
• Repeat steps 4 and 5 until all originals are scanned.
• Memory indicator on the upper right of the Basic Screen allows you to
check the remaining memory.
• To delete the scanned data without printing, press [STOP]. See p. 3-13 for
details.
See p. 5-9 to p. 5-10 if memory overflow occurs.
Should memory overflow occur frequently, it is recommended that you contact
your service representative to expand the memory capacity in your machine.
6.
Touch STORE to exit the Store mode.
STORE will no longer be highlighted.
7.
Press [START].
All the data in memory will be output.
Press [STOP] to suspend the scanning or printing job. See p. 3-13 for details.
W hen the fi nishe r / t rimme r u nit / pape r ex it tray cap acity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
3-34
Advertisement
Table of Contents
Troubleshooting
