Konica Minolta 8050 Instruction Manual page 30

CAUTION: Fixing Unit
The internal fixing unit is very hot. To avoid getting burned, DO NOT TOUCH. Be
careful when withdrawing the fixing unit.
WARNING: Drum Unit
The internal drum unit generates a high voltage.
To avoid an electrical shock, DO NOT TOUCH.
CAUTION: LCT Bottom Plate
To avoid any unexpected injury, DO NOT put your hand into the holes (3 places) on
the bottom plate of the LCT.
CAUTION: Disposal of Copier
Do not dispose of this copier yourself. Contact your service representative, who can
arrange for its safe disposal.
If you change the place of installation, please contact your service representative.
CAUTION: Paper Capacity for the Exit Tray
The exit tray capacity is max. 150 sheets (80 g/m
150 is required, be sure to remove the copies from the exit tray before the maximum
capacity is reached. Failure to do so will cause the copier to jam.
CAUTION: FS-115/215 Finisher Paper Capacity
The FS-115 Finisher is equipped with two exit trays, and FS-215 Finisher is
equipped with three exit trays.
Select an exit tray and output mode on the Output Mode popup menu.
To prevent paper misfeed, do not exceed the paper capacity of the Finisher.
When the total number of copies in the copy run exceeds the capacity stated in
Section 12, be sure to unload the exit tray while the copier is still copying. Failure to
do so will cause the copier to jam.
CAUTION: FS-115/215 Finisher Primary (Main) Tray
When printed materials are removed from the primary (main) tray of the Finisher, the
tray goes up automatically. To avoid injury, DO NOT put your hand on top of the
printed sheets. Be sure to hold both sides of the printed sheets when removing them,
and DO NOT leave your hand on the printed sheets while the primary tray goes up.
1-12
Requirements for Safe Use (continued)
2
paper). If a copy run of more than