Xerox DocuPrint 180 Message Manual page 98

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-20
OS1263 Form paper size out of range: xxxxxx.xxx
Paper size for form specified in the JSL is not supported by the IOT.
Action Contact your systems specialist.
OS1264 Barcode sequence mismatch
The IOT detected a sequence number other than the one expected.
Action Check the job, correct the reason for the mismatch and rerun.
OS1265 Printer status request already in progress
A previous request for printer status is still being processed.
Action None.
OS1267 ESS didn't confirm duplex hint
A sheet abort request was sent to the ESS from the IOT because the
ESS did not confirm a hint for the second side of a sheet already
committed to the paper path.
Action None.
OS1270 Command file aborted
The @ABORT command was entered. The system has abandoned
processing of the initiated command file.
Action None.
OS1271 Cannot nest command files. Check and retry.
The command file entered is formatted incorrectly. It appears to be
contained (nested) within another command file
Action 1. Correct your command file format. (Refer to your Xerox
DocuPrint 180 LPS Operations Reference chapter on creating
and using command files for additional information.)
2. Retry your command file request.
OS1272 Command file delaying
The .DELAY n command was entered. Command file processing is
being suspended for a specified period of time. (n = number of
seconds.)
Action None.
OS1273 Command file resumed
Following an interruption, command file operations have started
again.
Action None.
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE