Xerox DocuPrint 180 Message Manual page 297

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
Cannot open Master Directory file for crash recovery.
The record manager is unable to open the master directory file to
support crash recovery.
Action If the problem persists, call Xerox Customer Service.
Cannot read in-process file during crash recovery.
The record manager has detected an error while reading the in-
process file to support crash recovery.
Action If the problem persists, call Xerox Customer Service.
Cannot save a log onto itself.
You cannot save a console log to hard disk under the name "current
log."
Action Save the log under a different name.
Cannot use Reserved Words in file names.
The words CON, CLOCK$, AUX, COM(1-4), LPT(1-4), NUL, and
PRN are recognized by the PC User Interface as DOS commands
and therefore cannot be used in file names.
Action Rename any file that has these terms in the file name.
Client-Layer is established
The Xerox DocuPrint 180 LPS is communicating normally.
Action Before printing, check the PC user interface or printer control console
for instructions on clearing any existing faults. If you are instructed to
select CLEAR, you can either select the Clear Faults button on the
PC user interface screen, or enter CLE in the command line
message window.
Command sequence error, FGRP_HEADER not 1st.
The first group of report definitions must define the header; other
records were encountered.
Action If the problem persists, call Xerox Customer Service.
Command sequence error, group not larger than last.
At least one of the report definition groups is out of order.
Action If the problem persists, call Xerox Customer Service.
Command sequence error, number out of range.
Numeric parameter for a report definition command is out of range.
Action If the problem persists, call Xerox Customer Service.
XEROX DOCUPRINT 180 LPS ADDITIONAL MESSAGES
15-31