Xerox DocuPrint 180 Message Manual page 294

XEROX DOCUPRINT 180 LPS ADDITIONAL MESSAGES
15-28
Audit Logging state notification.
The auditor has changed state by either entering or leaving the active
auditing state.
Action None.
Audit report format already in progress.
The audit report formatter is already processing a request.
Action If the problem occurs when no audit logs are being displayed or
printed call Xerox Customer Service.
Bad block on tape device.
The tape drive is unable to read a specific block of data from the tape.
This could be caused by damaged media or a dirty or defective tape
drive.
Action 1. Clean the tape drive.
2. Replace the tape.
If the problem occurs when no audit logs are being displayed or
printed call Xerox Customer Service.
BTEXT date parameter exceeds 365 days.
The number of days specified in the BTEXT LDT parameter is too
large.
Action Check JSL or DJDE in job stream to ensure that all BTEXT LDT
keywords and parameters are correct.
BTEXT signal unrecognized; not PAG or RPT
A BTEXT keyword or parameter is invalid.
Action Check JSL or DJDE in job stream to ensure that all BTEXT keywords
and parameters are correct. This error occurs when data in the DJDE
BTEXT is completely unrecognizable
BTEXT signal Page Detail text invalid
BTEXT Page Detail text is incorrect.
Action Check JSL or DJDE in job stream to ensure that all Page Detail
BTEXT keywords and parameters are correct. Parameters to check
are SEQ, PRA, and TXT. If the problem persist, call Xerox Customer
Service
BTEXT signal text invalid
A BTEXT keyword or parameter is invalid.
Action Check JSL or DJDE in job stream to ensure that all BTEXT keywords
and parameters are correct.
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE