Fd (Forms Compilation) Messages - Xerox DocuPrint 180 Message Manual

FD (FORMS COMPILATION) MESSAGES

3-2
FD2720 Key-in too long. Reenter
The name or word entered exceeds the permitted number of
characters.
Action Enter a different word within the permitted range. (Refer to your
Xerox DocuPrint 180 LPS Forms Creation Guide .)
FD2730 Parameter too long. Reenter
The command parameter entered contained more characters than
permitted.
Action Reenter the command with an allowable number of characters.
(Refer to your Xerox DocuPrint 180 LPS Forms Creation Guide .)
FD2740 FSL not found or invalid option, check and retry
The Forms Source Library (FSL) file specified does not exist on
system disk. The compiler will abort.
Action 1. Check FSL for the correct file name.
2. Create the FSL file on disk if necessary. (Refer to your Xerox
DocuPrint 180 LPS Forms Creation Guide .)
3. Retry the FDL task.
FD2750 Unsupported tape device specified
You have entered the SUBDEV command, and referenced a tape
device that is currently not supported by this system.
Action Correct the reference parameter in the SUBDEV command. Refer to
your system administrator guide.
FD2915 Security violation
The requested file has been protected by the ABNORMAL
SECURITY = YES PDL statement. An attempt was made to access
it at an incorrect logon level.
Action To access the file, obtain correct password and logon at Level 5.
(Refer to your Xerox DocuPrint 180 LPS Operations Reference
chapter on setting LPS parameters for additional information.)
FD4500 Error in reading magnetic tape
The system is unable to read the input tape containing FDL. The
compiler will abort. (Refer to the maintenance chapter in your Xerox
DocuPrint 180 LPS Operator Guide .)
Action 1. Clean the magnetic tape drive. (Refer to the maintenance
chapter in your Xerox DocuPrint 180 LPS Operator Guide .)
2. If the problem recurs, recreate the FDL tape.
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE