Xerox DocuPrint 180 Message Manual page 183

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS6920 LINE exceeded page limit. Line truncated.
A new margin has taken effect or a new line was started. Current line
length is longer than page size. The excess has been cut off.
Action 1. Check the JDL/DJDE MARGIN commands and change the
margin size.
2. Ensure that the correct paper size was specified at sysgen.
3. If the problem recurs, recreate the job, changing line length,
font size, and/or carriage returns.
OS6949 Page density exceeded, page won't be printed. ABORT O or.
The page being imaged has too many characters per line. The page
will not print. (Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command to resume printing if data
loss is acceptable.
or
Enter the ABORT O command to cancel the job.
2. Recreate the job, reducing the amount of overprinting and/or
shading.
OS6950 LINE density exceeded, page won't be printed. ABORT O or.
The page being imaged has too many characters per line. The page
will not print. (Message is followed by message OS2000.)
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Enter the CONTINUE O command to resume printing if data
loss is acceptable.
or
Enter the ABORT O command to cancel the job.
2. Recreate the job, reducing the amount of overprinting and/or
shading.
OS6951 Unable to rasterize local density problem page.
An imaging error occurred while attempting to rasterize a page with
a local density problem. The page cannot be rasterized; i.e., a bitmap
image of the page cannot be produced.
Action None.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-105