Xerox DocuPrint 180 Message Manual page 255

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
Document printing terminated due to error(s).
The job was ended because of a previous error on the summary
sheet. This message is added to the actual error message.
Action None.
Error sheet only; document not printed due to errors.
This message is added to the actual error message if no data had
been formatted for printing when the job was aborted due to errors.
Action None.
(mapped from character nB, set nB).
When character mapping occurred for a particular character, that
character did not exist at the new location. The message ...character
not in font... is also issued.
Action None.
Note: In this message, the letter "B" indicates an octal value. No
font for output character set 0B, can not substitute blanks.
No font for output character set 0B, can not substitute blanks.
Character substitution failed because no substitute character was
defined for this Interpress family. This happens when LPS fonts are
not created through the FIS utility, or if no substitute character is
specified in the FIS master. This message follows the ... Font
Problem ... message.
Action None
Note: In this message, the letter "B" indicates an octal value.
No font for output character set nB, substituting for character
nB.
A font switch from a character set not in the Interpress family
mapping to LPS fonts occurred. The substitute character in another
character set replaces all characters referenced in character set n.
This message is preceded by the ... Font Problem ... message.
Action None.
Note: In this message, the letter "B" indicates an octal value.
SUMMARY SHEET ERROR MESSAGES
14-13