Xerox DocuPrint 180 Message Manual page 205

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS9800 Hardware error/Disk - Input. Call for service.
A fatal system disk error has occurred in input.
Action 1. Restart the job.
2. If the failure recurs, contact your systems specialist or Xerox
Customer Service.
OS9900 System cannot go "ONLINE."
The ONLINE command was entered, but a fatal error in online
interface prevents it from being processed.
Action 1. Reenter the ONLINE command.
2. If the failure recurs, contact your systems specialist or Xerox
Customer Service.
OS9910 System cannot go "READY."
A fatal error in the online interface has occurred during power-up.
Action 1. Repeat the powerup sequence. (Refer to the powering on and
off chapter in your Xerox DocuPrint 180 LPS Operator Guide .)
2. If the failure recurs, contact your systems specialist or Xerox
Customer Service.
OS9920 No system log. Call for service.
The system attempted to update the error log and found none for the
current job while printing.
Action 1. Enter the PROBLEM command to reinitialize the error log.
2. Rerun the job.
3. If the message reappears, contact your systems specialist or
Xerox Service Support Center. (May require reformat and
resysgen.)
OS9950 Memory is too degraded to use. Call for service.
Memory problems are sufficiently severe that there is not enough
memory to run, even in degraded mode.
Action 1. Reboot the system by pressing the Boot button, then entering
B.
2. If the message reappears, contact your systems specialist or
Xerox Service Support Center.
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-127