Xerox DocuPrint 180 Message Manual page 180

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-102
OS6760 Font char width table missing - word proc. aborting job.
An old (pre-V10 version) font file has been loaded. It cannot be used
for CWP jobs. Job is aborting.
Action 1. Restart job, using correct font tape.
2. Call Xerox Font Center for information on replacing font.
OS6761 Too many SEF Font mapping errors.
An exceedingly large number of Short Edge Feed font mapping
errors has occurred.
Action 1. Verify proper contents of mapping file and correct.
2. Rerun the job.
OS6780 Unsupported JDL option may jeopardize job integrity.
You have submitted a parameter in a DJDE or PDL command, such
as SESMAP or TRANS, which is not supported by 4050, 4090, 4650
printers. The appearance or position of your output may be affected.
Action 1. Check your output to see if it is satisfactory.
2. If the output is unsatisfactory, recode the JSL eliminating the
unsupported parameter.
OS6781 Unsupported DJDE option encountered. See OPRINFO Page.
A DJDE option was encountered which is not supported on this
printer.
Action Check OPRINFO page for unsupported option.
OS6782 Paper size exceeds printer capability.
In the PDL OUTPUT command you have specified a larger paper
size than the paper trays of the 4050, 4090, 4650 printers can
accommodate.
Action None.
OS6800 No XCS File specified for 850 job.
You have specified an invalid XCS file for 850 job.
Action Check your XCS file format.
OS6819 Improper file format. Record size is not 80 bytes.
The application has specified a disk-resident Ink List, but when the
file is accessed, it is found to be of the wrong format.
Action Check the application.
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE