Xerox DocuPrint 180 Message Manual page 111

XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS1563 SEF file not found
You have specified that the font mappings you wish to use in the job
are contained in a file that does not exist in the system. Job
processing will continue using the font specified in the PDE
statement.
Action If you wish to override the PDE font, verify the mapping file and
reenter the command.
OS1570 File protected--unable to dump
The system cannot print dump because the file is protected by the
SECURE filename.filetype command.
Action 1. Obtain the correct password and log on at Level 5. (Refer to
your Xerox DocuPrint 180 LPS Operations Reference chapter
on setting LPS parameters for additional information.)
2. Retry printout.
OS1600 Input task not active
The STOP I command was entered when input was already inactive
(i.e., no job had been sent or started.)
Action None.
OS1610 Output task not active
The STOP O command was entered or the Stop button was pressed
while the system was not printing.
Action None.
OS1620 Local density problem has caused a printer cycle down
A page was encountered with a local density problem; i.e., it contains
a line or lines that are too complex for the system to process
normally. The printer is cycling down to rasterize (produce a bitmap
image of) the page.
Action None.
OS1625 Local density problem rasterization in progress
A page with a local density problem is being rasterized for printing;
i.e., the system is producing a bitmap image of the page.
Note: This may take from 3 to 20 minutes.
Action Do not press any keys until the process is complete (Message
OS1627 appears).
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-33