Saving Oscilloscope Data - Agilent Technologies InfiniiVision 5000 Series User Manual

Saving Oscilloscope Data

N O T E
InfiniiVision Oscilloscopes User's Guide
Here are a few points about saving oscilloscope data:
• You can save a waveform trace and recall it later. The recalled trace appears in cyan
(blue).
• You can save oscilloscope setup parameters and recall them later. The setup file
stores settings such as horizontal timebase, vertical sensitivity, trigger mode, trigger
level, measurements, cursors, and math functions. This lets you easily and
consistently set up the oscilloscope to make a particular measurement.
• There is a distinction between print and save: print always refers to printing the
display to a printer. Save means saving data to a USB mass storage device or the
oscilloscope's internal memory.
The following table shows types of data and where the data can be saved.
S O D
AVING SCILLOSCOPE ATA
Type of Data
Oscilloscope setup and waveform trace
Display image and waveform data files
(BMP, PNG, CSV, ASCII XY, ALB, BIN)
*If Secure Environment Mode option is installed then data is prevented from being
stored in the oscilloscope's internal memory.
You can also save the oscilloscope's display image using a web browser. See
Image" on page 285 for details.
Printing and Saving
Can be saved to:
USB Oscilloscope's
device internal memory
Yes Yes*
Yes No
7
"Get
247