Agilent Technologies InfiniiVision 5000 Series User Manual page 296

10
Serial Decode/Lister
296
4 Specify the CAN signal:
a Press the Settings softkey to access the CAN Signals Menu.
Baud rate
Signal
Source
5 Press the Source softkey, and use the Entry knob to select the channel for the CAN
signal.
If you have connected one of the oscilloscope's analog source channels to the CAN
signal: Adjust the trigger level for the selected analog channel to the middle of the
waveform by turning the Trigger Level knob.
If you have connected one of the oscilloscope's digital source channels to the CAN
signal (this applies to MSO model oscilloscopes only): Press the [D15-D0] key and
select Thresholds to set an appropriate threshold level for digital channels.
Currently selected
channel
Sample
Point
InfiniiVision Oscilloscopes User's Guide
Trigger level
Return to
previous menu