Agilent Technologies InfiniiVision 5000 Series User Manual page 311

N O T E
InfiniiVision Oscilloscopes User's Guide
2 Press the Settings softkey to open the I
Signals Bus
menu configuration
menu
a Press the Signals softkey to open the I
select the oscilloscope channels that probe the serial clock, Word Select, and
serial data lines. It is the same menu you use when setting up I
information about the options in this menu, see
b Press the Bus Config softkey to open the I
is where you identify the device under test's I
use when setting up I
menu, see step 11
c Press the Base softkey to select the number base in which to display decoded data.
3 If the decode waveform does not appear on the display, press the up-arrow softkey to
return to the previous menu, then press the Decode softkey to turn it on.
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and decode data.
If the setup does not produce a stable trigger, the I2S signal may be slow enough that the
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the Zoom horizontal sweep mode for easier navigation of the acquired data.
2
S Settings Menu.
Number
base for
decode
2
S Signals Menu. This menu is where you
2
S triggers. For more information about the options in this
on page 123.
Serial Decode/Lister
2
S triggers. For more
step 6 on page 122.
2
S Bus Configuration Menu. This menu
2
S bus setup. It is the same menu you
10
Return to
previous menu
311