Interpreting Lin Decode - Agilent Technologies InfiniiVision 5000 Series User Manual
Infiniivision 5000/6000/7000 series oscilloscopes
Hide thumbs
Also See for InfiniiVision 5000 Series:
- Programmer's manual (788 pages) ,
- Service manual (126 pages) ,
- Demo manual (10 pages)
Table of Contents
Advertisement
N O T E
Interpreting LIN Decode
InfiniiVision Oscilloscopes User's Guide
5 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and decode data.
If the setup does not produce a stable trigger, the LIN signal may be slow enough that the
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the Zoom horizontal sweep mode for easier navigation of the decoded data.
• Angled waveforms show an active bus (inside a packet/frame).
• Mid-level blue lines show an idle bus (LIN 1.3 only).
• The hexadecimal ID and parity bits (if enabled) appear in yellow. If a parity error is
detected the hexadecimal ID and parity bits (if enabled) appear in red.
• Decoded hexadecimal data values appear in white.
Serial Decode/Lister
10
317
Advertisement
Table of Contents
