Display Mode Setup - Standard Horizon HX851E Owner's Manual

6.4.1 TRANSMIT TIME - OUT TIMER ( TOT )
While the PTT switch is held down, transmission time is limited to 5 minutes.
This prevents prolonged (unintentional) transmissions. About 10 seconds be-
fore automatic transmitter shutdown, a warning beep sounds from the speaker.
The transceiver automatically switches to the receiving mode, even if the PTT
switch is held down. Before transmitting again, the PTT switch must first be
released, then pressed again after 10 seconds. This Time-Out-Timer (TOT)
prevents a continuous transmission that would result from an accidentally stuck
PTT switch.
The PTT switch will not operate for 10 seconds after the transceiver
automatically switches to the receiving mode by the TOT feature.

6.5 DISPLAY MODE SETUP

The HX851E display can be setup to show Radio information with GPS icon,
GPS Position, GPS Position with SOG and COG, and GPS status with the
procedure below.
1. Press and hold the [ CALL ( ENT ) MENU ] key until the
"Setup Menu" appears.
2. Select "Radio Setup" with the [ ] / [ ] key, then press
the [ CALL ( ENT ) MENU ] key.
3. Select "Display" with the [ ] / [ ] key, then press the
[ CALL ( ENT ) MENU ] key.
4. Select the desired Display Type with the [ ] / [ ] key.
Radio:
Position:
Navigation: Displays your position, COG (Course
Compass:
Waypoint:
GPS Status: Displays apparent reception of GPS satellites, including the
5. Press the [ CALL ( ENT ) MENU ] key to store the selected setting, and return
to radio operation mode.
Page 24
Displays the "
Displays your position and current time
on the display.
Over Ground: your current direction), and
current time on the display.
Displays your SOG (Speed Over Ground: your current speed),
COG (Course Over Ground: your current direction) by the
Rose Compass.
Displays the distance and direction of the received vessel, and
also the compass indicates the received vessel by dot ( ) .
bar-graph of signal strengths.
NOTE
" icon only.
HX851E