7.8.2 SETTING UP THE POSITION REQUEST RINGER
The HX851E has the capability to turn off the Position Request ringer.
1. Press and hold the [ CALL ( ENT ) MENU ] key un-
til "Setup Menu" appears.
2. Press the [ ] key to select "DSC Setup" menu.
3. Press the [ CALL ( ENT ) MENU ] key, then select
"DSC Beep" with the [ ] / [ ] key.
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select "Position Re-
quest", then press the [ CALL ( ENT ) MENU ] key.
6. Press the [ ] key to select "Off".
7. Press the [ CLR ] key twice to return to the "Setup
Menu", then press the [ CLR ] key again to return
to radio operation.
To enable the ringer tone, repeat the above procedure,
press the [ ] key to select "On" in step "6" above.
7.8.3 TRANSMITTING A POSITION REQUEST TO ANOTHER VESSEL
Pre-Programmable Request
1. Press the [ CALL ( ENT ) MENU ] key. The "DSC Call
Menu" will appear in the display.
2. Press the [ ] / [
quest".
3. Press [ CALL ( ENT ) MENU ] key to show the "Position
Request Call" directory. This directory uses the
"Individual Call" directory information.
4. Press the [ ] / [ ] key to select a name, then
press the [ CALL ( ENT ) MENU ] key.
5. Press the [ CALL ( ENT ) MENU ] key again to
transmit the Position Request DSC call.
6. When the HX851E receives the position from
the polled vessel, a ringing alarm will sound, and
the display shows the position of the vessel and
also transferred to a GPS Chart plotter if con-
nected.
7. Press any key to stop the alarm.
8. If you wish to display the position of the polled vessel
on the "WAYPOINT" screen, go to next step, other-
wise press the [ CLR ] key to return to radio operation.
9. Press the [ CALL ( ENT ) MENU ] key to enter the "Waypoint Input" menu.
HX851E
] key to select the "Pos Re-
Page 51