8.8 SCAN RESUME
This selection is used to select the time which the HX851E waits after a trans-
mission ends before scanning is started. The default setting is "2sec".
1. Press and hold the [ CALL ( ENT ) MENU ] key until "Setup
Menu" appears.
2. Press the [ CALL ( ENT ) MENU ] key, then select "SCAN
Resume" in the "Radio Setup" menu with the [ ] / [ ]
key.
3. Press the [ CALL ( ENT ) MENU ] key.
4. Press the [ ] / [ ] key to select the desired resume
time. The resume time can be set to "1/2/3/4/5 sec" or
"Off". In the "Off" selection, the scanner will resume af-
ter the other station stops transmitting (carrier drops).
5. Press the [ CALL ( ENT ) MENU ] key to store the selected
setting.
6. To exit this menu and return to radio operation mode press the [ 16/9 ] key
or press the [ CLR ] key several times.
8.9 KEY BEEP
This selection controls the loudness of the key beep or turns it off. The default
setting is "Level 5".
1. Press and hold the [ CALL ( ENT ) MENU ] key until "Setup
Menu" appears.
2. Press the [ CALL ( ENT ) MENU ] key, then select "Key
Beep" in the "Radio Setup" menu with the [ ] / [ ] key.
3. Press the [ CALL ( ENT ) MENU ] key.
4. Press the [ ] / [ ] key to select the desired beep level.
The beep level can be set to "Level 1", "Level 2", "Level
3", "Level 4", "Level 5", "Level 6", "High", or "Off".
5. Press the [ CALL ( ENT ) MENU ] key to store the selected
setting.
6. To exit this menu and return to radio operation mode
press the [ 16/9 ] key or press the [ CLR ] key several
times.
Page 64
HX851E