Standard Horizon HX851E Owner's Manual page 31

7.2.2 USER MMSI PROGRAMMING
A user MMSI can be inputted only once (as per governmental regula-
tion). Therefore please be careful not to input the incorrect MMSI num-
ber. If you need to change the MMSI after it has been programmed, the
radio will have to be returned to Factory Service. Refer to the section
"13.3 FACTORY SERVICE".
1. Press and hold down the [ CALL ( ENT ) MENU ]
key until the "Setup Menu" appears.
2. Press the [ ] key to select "DSC Setup" menu.
3. Press the [ CALL ( ENT ) MENU ] key, then select
"User MMSI" with the [ ] / [ ] key.
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select the first number
o f y o u r
[ CALL ( ENT ) MENU ] key to step to the next num-
ber.
6. Repeat step 5 to set your MMSI (nine digits).
7. If a mistake was made entering, repeatedly press
the [ H/L (
then press the [ ] / [ ] key to correct entry.
8. When finished programming the number, press and
hold the [ CALL ( ENT ) MENU ] key. A confirmation mes-
sage will appear on the display. Set your MMSI num-
ber again, then press and hold the [ CALL ( ENT ) MENU ]
key.
9. Press the [ CALL ( ENT ) MENU ] key to store the MMSI
number in memory.
10. Press the [ CLR ] key twice to return to radio operation.
VHF handhelds used in the United States should use the MMSI assigned
to the ship to which the handheld is primarily associated, even if another
radio on that ship uses the same MMSI. If you plan to use the handheld
on other boats, you might want a separate MMSI number so that you can
update the registration according to which boat it is currently on.
European users should check with the local marine regulatory authority in
their country for assistance in obtaining an MMSI for handheld DSC radio.
HX851E
M M S I , t h e n
)] key until the wrong number is selected,
IMPORTANT NOTE
WARNING
p r e s s t h e
Page 31