Standard Horizon HX851E Owner's Manual page 52

10. Press and hold the [ CALL ( ENT ) MENU ] key several
times until replace the display to the "WAYPOINT"
Screen. The display indicates the distance and direc-
tion of the polled vessel, and also the compass indi-
cates the polled vessel by dot ( ) .
11. To stop navigating to the location of the position re-
quest call:
1) Press and hold down the [ CALL ( ENT ) MENU ] key
until "Setup Menu" appears.
2) Press the [ ] / [ ] key to select "Radio Setup".
3) Press the [ CALL ( ENT ) MENU ] key, then select "Display" with the [ ] /
[ ] key.
4) Press the [ CALL ( ENT ) MENU ] key, and select "Radio", "Position", "Navi-
gation" or "Compass" other than "Waypoint", and press the
[ CALL ( ENT ) MENU ] key.
If the HX851E does not receive position data from the polled vessel, the
display will show "NO POSITION DATA".
Manual Request
You may enter an MMSI number manually to contact without Setting up the
Individual / Position Call Directory.
1. Press the [ CALL ( ENT ) MENU ] key. The "DSC Call
Menu" will appear in the display.
2. Press the [ ] / [
quest".
3. Press [ CALL ( ENT ) MENU ] key to show the "Position
Request Call" directory. This directory uses the
"Individual Call" directory information.
4. Press the [ ] / [ ] key to select the "Manual",
then press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to scroll through num-
bers, 0-9. To enter the desired number and move one
space to the right press the [ CALL ( ENT ) MENU ] key.
Repeat this procedure until all nine spaces of the MMSI number which you
want to contact are entered. If a mistake was made entering in the MMSI
number repeatedly press the [ H/L (
lected, then press the [ ] / [ ] key to correct the entry.
6. When finished entering the MMSI number, press and hold the
Page 52
NOTE
] key to select the "Pos Re-
)] key until the wrong number is se-
HX851E