Sog Unit; Pos Data Priority - Standard Horizon HX851E Owner's Manual

10.8 SOG UNIT

Allows the SOG shown on the NAV display to be shown in Kts (knot), MPH
(mile/hour) or KPH (kilo-meter/hour). The default setting is "Kts: Knots".
1. Press and hold the [ CALL ( ENT ) MENU ] key un-
til "Setup Menu" appears.
2. Press the [ ] key to select "GPS Setup" menu.
3. Press the [ CALL ( ENT ) MENU ] key, then select
"SOG Unit" in the "GPS Setup" menu with the [ ] / [ ]
key.
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select the desired unit.
6. Press the [ CALL ( ENT ) MENU ] key to store the
selected setting.
7. To exit this menu and return to radio operation mode
press the [ 16/9 ] key or press the [ CLR ] key several
times.

10.9 POS DATA PRIORITY

This menu item allows the HX851E to:
a. use the internal GPS to compute and display position information (de-
fault setting)
b. use the NMEA output of an external GPS Chart Plotter to input position
information into the HX851E. This is a useful feature when the HX851E
is located in an area where GPS reception is limited and this selection
increases battery life of the HX851E between charges.
1. Press and hold the [ CALL ( ENT ) MENU ] key un-
til "Setup Menu" appears.
2. Press the [ ] key to select "GPS Setup" menu.
3. Press the [ CALL ( ENT ) MENU ] key, then select
"POS DATA Priority" in the "GPS Setup" menu with the
[ ] / [ ] key.
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select "Internal GPS"
or "External I/O port".
6. Press the [ CALL ( ENT ) MENU ] key to store the selected
setting.
7. To exit this menu and return to radio operation mode
press the [ 16/9 ] key or press the [ CLR ] key several
times.
HX851E Page 73